On the passenger's side of my truck's intake manifold are three fittings.
One is for the PCV Valve Hose and then there are two other fittings. One
goes to the MAP Sensor and the other just goes somewhere else. Would it
matter if these two were switched and not hooked up? I know I have the PCV
Hose going to the right spot, just unsure if the other smaller hoses are on
the right fittings, if it even matters. Thanks.
Kyle
93 Dakota 4x4 V6
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:46 EDT