Re: Vacuum Hose Port Question

From: jon@dakota-truck.net
Date: Sun Jun 10 2001 - 01:31:07 EDT

Next message: Paul B Bumann: "Re: Re: RE: Re: Test"
Previous message: jon@dakota-truck.net: "Re: posting to dml offtopic"
In reply to: Kyle Kozubal: "Vacuum Hose Port Question"
Next in thread: Shawn Bowen: "Two more Vacuum Question's/FSM's"
Reply: Shawn Bowen: "Two more Vacuum Question's/FSM's"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

"Kyle Kozubal" <grndak4x4@home.com> wrote:
: On the passenger's side of my truck's intake manifold are three fittings.
: One is for the PCV Valve Hose and then there are two other fittings. One
: goes to the MAP Sensor and the other just goes somewhere else. Would it
: matter if these two were switched and not hooked up? I know I have the PCV
: Hose going to the right spot, just unsure if the other smaller hoses are on
: the right fittings, if it even matters. Thanks.

Kyle,

No, it shouldn't matter; they're both just a source of vacuum.

-Jon-

.---- Jon Steiger ------- jon@dakota-truck.net or jon@jonsteiger.com -----. | Affiliations: AOPA, DoD, EAA, NMA, NRA, SPA, USUA; Rec & UL Pilot - SEL | | '92 Ram 150 4x4 V8, '96 Dakota V8, '96 Intruder 1400, '96 FireFly 447 | `------------------------------------------ http://www.jonsteiger.com ----'

Next message: Paul B Bumann: "Re: Re: RE: Re: Test"
Previous message: jon@dakota-truck.net: "Re: posting to dml offtopic"
In reply to: Kyle Kozubal: "Vacuum Hose Port Question"
Next in thread: Shawn Bowen: "Two more Vacuum Question's/FSM's"
Reply: Shawn Bowen: "Two more Vacuum Question's/FSM's"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:46 EDT