>
> Okay, PC buffs. I am trying to install a new Maxtor Diamondmax VL 30 GB
> hard drive in an old PC of mine. This old PC is a P-II 333 mhz.
> Motherboard has the 440 LX chipset on it.
>
> When I boot up I get the following error:
>
> ERROR-Resource Conflict PCI Network Controller
> Bus: 00, Device: 10,
> Function: 00
>
> Why?
Is this new drive on the 1st or second IDE port? If it's on the second then
possibly you had it(the 2nd IDE port) disabled which allowed the P&P PCI
Network controller use that resource(either the IRQ or the Address). Dod you
do anything in the CMOS???
Greg
2K1 Neon ES
Rahway, NJ
http://24.6.89.18/Neon
24.6.89.18:6667 (IRC)
ICQ:283886
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:49 EDT