I'll have to research it next week since i'm leaving to the weekend in a few
minutes but the canadian daks (i believe) already have this on them. I know
that there is a part that gets plugged in and it will do this for you. I
found it in my fsm.
Jeff Durling
'01 4x2 QC SLT+
"Chris M. Giard" wrote:
> Hello.
> I'm new to the list, and I have searched the archives, but I haven't
> found a definitive answer to this. I just recently got a copy of the
> '01 Service Manual and Body Diagnostics Procedure manual. After looking
> through it, it looks like all that would be required to wire the Lo
> beams to stay on with the Hi beams would be to short 2 pins (pins 6 & 9)
> on the wiring harness for the Multi-Function Switch (the
> turn-signal/hi-lo beam selector). The schematic shows that the switch
> is only sensed, and the CTM does the actual switching.
>
> Has anyone tried this, or is it definitely going to trip the MIL?
>
> =====================================
> Chris M. Giard / cgiard@magerealm.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:51 EDT