I sense someone speaking from experience :)
Bernd D. Ratsch wrote on Sunday 24 June 2001 10:52 am:
>
> Hehehehehe....and don't forget to take the rag out either. ;)
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@BUFFNET.NET
> [mailto:owner-dakota-truck@BUFFNET.NET] On Behalf Of Andy Levy
> Sent: Sunday, June 24, 2001 9:17 AM
> To: dakota-truck-moderator@bent.twistedbits.net
> Subject: Re: DML: Re: 180deg tstat Help
>
>
> Make sure you stuff a rag into the hole the stat came out of before you
> go scraping. You don't want old gasket material getting into your
> cooling system.
>
> Chuck Robbins wrote:
>>
>> Reach in there with your finger and grab hold. If you can't get it
>> that way, use a small screwdriver and wedge it in the top of the
>> T-stat. Don't use anything to try and get under the T-stat because you
>
>> might scratch the gasket flange. Once the T-stat is off, then use a
>> screwdriver or putty knife and very carefully remove any of the old
>> gasket.
>>
>> --
>> Chuck Robbins
>
>
-- -andyhttp://home.twcny.rr.com/andylevy/ --- andylevy@yahoo.com ------------------------------------------------------------- modesty, n.: Being comfortable that others will discover your greatness -------------------------------------------------------------
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:51 EDT