Hehehehehe....and don't forget to take the rag out either. ;)
- Bernd
-----Original Message-----
From: owner-dakota-truck@BUFFNET.NET
[mailto:owner-dakota-truck@BUFFNET.NET] On Behalf Of Andy Levy
Sent: Sunday, June 24, 2001 9:17 AM
To: dakota-truck-moderator@bent.twistedbits.net
Subject: Re: DML: Re: 180deg tstat Help
Make sure you stuff a rag into the hole the stat came out of before you
go scraping. You don't want old gasket material getting into your
cooling system.
Chuck Robbins wrote:
>
> Reach in there with your finger and grab hold. If you can't get it
> that way, use a small screwdriver and wedge it in the top of the
> T-stat. Don't use anything to try and get under the T-stat because you
> might scratch the gasket flange. Once the T-stat is off, then use a
> screwdriver or putty knife and very carefully remove any of the old
> gasket.
>
> --
> Chuck Robbins
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:51 EDT