I might try that, the dyno shop here in Santee doesn't do it that way, so
I run with what they give me.
Checkout http://www.dynoshop.com/dynoshop/chip.html
Sam
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Jon Smith
> Sent: Sunday, July 01, 2001 5:41 AM
> To: dakota-truck@buffnet.net
> Subject: RE: DML: MSD
>
>
> Sam, unhook the TV cable from the TB... I let it go into 3rd at an idle,
> then floor it :) WOT in 3rd from ~1600 till I let off.. at
> least it works
> on my Gen II, not sure if the 46re tranny would react differently or not
>
>
> On 2001.07.01 00:23 Sam Parthemer wrote:
> >
> > From my dyno testing, the MSD does nothing above 3000 rpm for me.
> > I cannot dyno reliably below 3000 rpm (auto trans), but I do find I
> > get less pinging with the MSD 6A under hot/heavy load conditions.
> > Recommendation-- buy something else.
> >
> > Sam '00 RT (240 rwhp / 345 ft lbs.)
> >
> >
> >
> >
> --
> _______________
> Jon Smith
> Raleigh, NC
> www.fast4x4.net
> '94 CC 4x4 318
> 344rwhp/424rwtq
> ~~~~~~~~~~~~~~~
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:03 EDT