Just a thought, is the new coil bolted to a good ground???
Shawn
-----Original Message-----
From: owner-dakota-truck@BUFFNET.NET
[mailto:owner-dakota-truck@BUFFNET.NET]On Behalf Of Chuong Nguyen
Sent: Sunday, July 08, 2001 6:04 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: RE: stumbling problem. new discovery..... MSD ???
ignition?
Well, the MSD digital 6 was JUST bypasses, all new plugs were replaced and
it helped reduce the voltage leaking from the coil wire (running down the
side of the protruded area for the coil/plug and hits the ground (-)
connector on the blaster 2 coil.
I did an ohms test on the wires and they all checked out good. This is a
very recent problem.
As for going back to the basics, I kinda went snip happy when I took off my
stock coil so I can't just REPLUG it back in, because there's no room on
the harness to solder/connect more wires to. Yea, it was stupid, but msd
didn't have their wiring harness for me at the time and I didn't think about
it. I'm gonna try putting on another msd blaster 2 coil and seeing if it
solves the problem (an extra one I had around). Otherwise, What would
cause this voltage leak???
-Chuong
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:04 EDT