Well, the post about the wire looms got me thinkin' about what else may
fit that's readily available.
Spectre P/N# 4596 works very well on a V6 and V8. It comes with four
CHROME stand-off's with BLUE wire looms (RED also available but don't
have the P/N# handy).
Since you normally route the wires behind the rear of the valve covers,
there's enough slack to run them across the top of the valve covers
(moving the wires away from your manifolds or headers). You can use
your factory bolts/studs for those with the factory valve covers or
replace them with either a stud kit (also at PepBoys) or bolts to clean
things up a bit.
Cost: about $10 at PepBoys
- Bernd
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:10 EDT