Will they fit fatter wires (8.5-10mm)?
"Bernd D. Ratsch" wrote:
> Well, the post about the wire looms got me thinkin' about what else may
> fit that's readily available.
>
> Spectre P/N# 4596 works very well on a V6 and V8. It comes with four
> CHROME stand-off's with BLUE wire looms (RED also available but don't
> have the P/N# handy).
>
> Since you normally route the wires behind the rear of the valve covers,
> there's enough slack to run them across the top of the valve covers
> (moving the wires away from your manifolds or headers). You can use
> your factory bolts/studs for those with the factory valve covers or
> replace them with either a stud kit (also at PepBoys) or bolts to clean
> things up a bit.
>
> Cost: about $10 at PepBoys
>
> - Bernd
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:10 EDT