Jon,
Thanks for the reply.......no I can't find a loose hose flappin around. It started.... the lightbthat is after I put the AIT Adjuster on. I checked all the connections but I'll checlk the plug on the sensor itself. Maybe somweone with a 98 v6 can take a look at there motor for me.
Thanks
Bob
Original Message:
-----------------
From: Jon Smith jon@fast4x4.net
Date: Sat, 11 Aug 2001 21:31:48 -0400
To: dakota-truck@buffnet.net
Subject: DML: Re: Small Vaccuum Port Help Needed
Intake air too hot code would be set off by the IAT sensor, are you sure
it's plugged in tightly? Depending on the year of the truck, it might be
the hose to the EGR valve (pre '96 had EGR). Otherwise it should go to the
PCV vavle or Evap Canister Purge solenoid. Being a 1/4" hose I would
suspect it's a vacuum line to the purge solenoid or EGR valve.. is the hose
still on the truck? see any loose hoses dangling around?
__________________
Jon Smith
Raleigh, NC
'95 CC 318 4x4 auto
344rwhp/424tq
Hey Guys,
I need some help with a small vaccum port on the left side (looking at the
motor)which looks like it takes a 1/4" hose...I can't find the hose....it
mighta fell off. When I block it with my finger the truck stalls...it may be
why my check engine light "Intake air too hot code" came up. Can anyone tell
m,e where the hose goes?
Thanks,
Bob
--------------------------------------------------------------------
Mail2Web - Check your email from the web at
http://www.mail2web.com/ .
--------------------------------------------------------------------
Mail2Web - Check your email from the web at
http://www.mail2web.com/ .
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:24 EDT