i was told u need 4 degree shims
----- Original Message -----
From: <MrDakota95@aol.com>
To: <dakota-truck@buffnet.net>
Sent: Tuesday, August 14, 2001 8:51 AM
Subject: DML: Pinion Angle?
> Hey List, As some of you may remember I was in the process of lowering my
95
> CC
> 2wd well I got the 2 inch drop springs in the front I dropped the rear 3
in.
> with blocks and I added 2 degrees of pinion angle back to it with shims. I
> still have a shudder from a standing start, my ? is does any one know what
> the correct pinion angle should be on my truck, I'm going to put a pinion
> angle gauge on it tonight and would like to know where it should be to
get
> back to factory specs. I'm also rebuilding the front brakes after 58,000
> miles with new rotors, bearings and pads. The factory ones were getting
> pretty thin. Next project is a locker install to get rid of the one wheel
> wonder.
>
> Thanks
>
> Shawn
> MrDakota95
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:25 EDT