Again, where exactly is the suggested place for routing the wire through
the firewall?
I see only two possibilities: Run it through with the wire harness (pretty
sure it will be too short)
Run it through with the hood latch cable (might be
just barely long enough)
I have placed my IAT Adjuster in the Ash Tray.
----------------------------------------------------------------------------------------------------------------------------------------------------
Also, I'd like to have a "clean" installation . . . i.e., I would like to
use connectors . . .
. . . where can I get Male/Female connectors of the type used on the IAT
sensor ???
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:32 EDT