http://www.speedtweaks.net/posilock.htm
""Clinton O Holter"" <coholter@west.raytheon.com> wrote in message
news:OFDD581D03.A78E8B3B-ON88256AB2.0051750E@rsc.raytheon.com...
> Again, where exactly is the suggested place for routing the wire through
> the firewall?
>
> I see only two possibilities: Run it through with the wire harness
(pretty
> sure it will be too short)
> Run it through with the hood latch cable (might be
> just barely long enough)
>
> I have placed my IAT Adjuster in the Ash Tray.
>
> --------------------------------------------------------------------------
--------------------------------------------------------------------------
>
> Also, I'd like to have a "clean" installation . . . i.e., I would like to
> use connectors . . .
>
> . . . where can I get Male/Female connectors of the type used on the IAT
> sensor ???
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:33 EDT