Yes, the interior was the same. Dodge offered both buckets and a split
bench for the Dakotas, but I believe the splitbench was only available on
the club cabs. However, I'm sure it will fit dimensionally and probably
bolts in the same location.
David
> [Original Message]
> From: Gus <crtech@hot.rr.com>
> To: Dakota Truck List <dakota-truck@buffnet.net>
> Date: 9/5/01 3:38:39 PM
> Subject: DML: Gen I dakota questions
>
> Hello, I have a 1989 Dakota. Standard cab with long bed. I have several
> questions.
>
> 1) Sam south said "I think the Gen I and GenII have the same interior, so
> the pillar should be the same." Can anyone verify this. It was in
relation
> to a 3 gauge pod from lo-tek. I have been looking for some way to mount
> some gauges in a better way than what they are currently mounted.
>
> 2) I have a bench seat in the truck. My wife hates it. Doesn't really
like
> to ride in it. Did dodge make a bucket seat or 60/40 seat for it. If so
> could anyone give some information on what would fit.
>
> On a tight budget because I just had the A/C, and rack and pinion
replaced.
> Right after that I had to replace the 7.25 with an 8.25. Carrier bearing
> went out and got caught in the ring and pinion. Long story. Working on a
> web site for the swap.
>
> Thanks for any help.
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:44 EDT