i have my switches for my stereo system in place of the "clip". looks
awesome.. i'll send ya a pic if you want to see it.
ttyl
""Kevin (MAGNUM S/T) Hoegen"" <kevinhoegen@email.com> wrote in message
news:9o630s$966$1@bent.twistedbits.net...
> Hello,
> I plan to install my first neon light, and would like to have the 'fused
> distribution block' located in the last upper compartment on the overhead
> console (think it is intended for a garage door opener). There is plenty
of
> space for the fuse block..and I don't use that compartment for anything,
so
> it will allow very easy access to the fuses if needed.
>
> Additionally I may even put the lighted switch somewhere on this overhead
> console as well....I'm looking at the "clip" location.
>
> My question: I would like any suggestions on how I can run wires to this
> area. I am slightly hesitant about pulling the roof lining apart as I have
> never done this...so I don't know if it will go back the same way. I have
to
> run a wire from the relay (located in the engine compartment) to this
dist.
> block. I also have to run the sire from the neon light itself (currently
> just a licence plate light.
> I could really use some suggestions about WHERE the best places to run
wires
> are. For the upper console and running wires from the tailgate.
>
> Note: I am not planning on using pre-exisiting wiring for any of my
> connections. All my current and future neons will be on this dedicated
fused
> circuit. I am just not familiar with the interior body panels and good
ways
> and locations to run wiring.
>
> TIA
>
> --
> Kevin Hoegen
> 99 Solar Yellow MAGNUM S/T CC
> http://webpages.charter.net/khoegen
> Flowmaster 3-chamber Dual outlet
> Stillen RP w/Dual Hooker Euro tips
> Quick-D TB/K&N Intake
> 180 RS T-stat/Taylor wires/Autolite plugs
> Centerforce II clutch
> SpeedTweaks IAT adjuster...etc....etc
> (add your link to my site:
http://webpages.charter.net/khoegen/links.html )
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:50 EDT