Wouldn't you also need a computer, as the V6/I4 computers only send signals
to 6/4 injectors and not 8.
Geoff
""Ryan Beverlin"" <streetdak@hotmail.com> wrote in message
news:OE72JHlYRVWlzHjRY5b0000f048@hotmail.com...
> ACTUALLY , if you have a 3.9 already all you have to do is get the motor ,
> your motor mounts and frame mounts will directly bolt up so you don't even
> have to buy the motor mounts unless there needbe . All you need is the
Motor
> , and wiring harness , its a direct bolt in and plug in play , now if your
> doing a pre magnum motor its a whole different story cause that motor
> doesn't have bosses in the side of the block , then id go w/ Engine Swaps
> Simplified , www.engine-swaps.com , or be creative like me , use v6/v8
frame
> mounts and Grand Cherokee motor mounts , (I suggest the engine swaps kit ,
I
> would have used it but when I did the conversion it wasn't available) or
> your fire wall will be fun to beat in lol .
> Ryan Beverlin
> (1992 Dak Carbed V8 Conversion)
> http://home.houston.rr.com/burnout/ryan.html
>
> ----- Original Message -----
> From: "Ryan Beverlin" <streetdak@hotmail.com>
> To: <dakota-truck@buffnet.net>
> Sent: Saturday, October 13, 2001 1:36 PM
> Subject: Re: Fw: Swapping engines, read me
>
>
> > If your switching to a Magnum Motor , all You have to do is Buy Frame
> Mounts
> > and Motor mounts from MOPAR , its Direct Bolt in , no need even for a
> Motor
> > Kit , The V6's and the V8's have the same exact mounting locations ,on a
> > Magnum Motor there's Bosses welded and Drilled in the side of the block
,
> > you don't even use the ears towards the front of the motor .
> >
> > ----- Original Message -----
> > From: "kwreimer" <kwreimer@email.msn.com>
> > To: <dakota-truck@buffnet.net>
> > Sent: Saturday, October 13, 2001 10:31 AM
> > Subject: DML: Fw: Swapping engines, read me
> >
> >
> > >
> > > ----- Original Message -----
> > > From: "kwreimer" <kwreimer@email.msn.com>
> > > To: <dakota-truck@buffnet.net>
> > > Sent: Friday, October 12, 2001 7:01 PM
> > > Subject: Swapping engines, read me
> > >
> > >
> > > > An ad in Mopar Magazine, engine swap kits. from a 4 CYL to a V-8 no
> > > > problem.no welding, no cutting, for 1987-1996 Dakota two wheel drive
> > only,
> > > > call these guys at Schumacher Creative Srvcs.Seattle, Wash.
> > 206-364-7151
> > > /
> > > > or www.engine-swaps.com
> > > >
> > >
> > >
> >
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:16 EDT