Re: low coil voltage

From: TonyC (acellan1@tampabay.rr.com)
Date: Sat Oct 20 2001 - 17:52:54 EDT


If you have the stock PCM, throw it it, and see if you still have the
problem. If not PCM, is so, check your ASD relay. Beyond that, ask again.
TonyC

-----Original Message-----
From: JAMEPC@aol.com <JAMEPC@aol.com>
To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
Date: Saturday, October 20, 2001 5:43 PM
Subject: DML: low coil voltage

>My battery is fully charged (12.67 v.). With the key in the on position,
>truck not started, I get a reading of 0 volts at the coil. When I
disconnect
>the + coil wire, I get a reading of only 3.75v. I tested where the coil
>wire comes out of the PCM (pin 19) and get 3.75 v. there also. The truck
>does run but then quits after it gets hot. I have a MP PCM and a blaster
>coil. I bypassed the MSD for testing. I get the same readings with the
stock
>coil (w/ 190,000) miles hooked up. Please help
>James
>



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:20 EDT