Are you talking about having the pipes exit through the roll pan? Because, I
had it done. I actually had to have about a foot of the Gibson pipes cut off
and new pipes re-bent. Depending on where you want the pipes to exit, the
frame rails can get in the way. I was also only able to use 2.5" tips. I
think you'll find the Gibson exits too low to put through a roll pan
(however, I had been involved in a little rear end collision, so I need a
few feet of new pipe anyway).
Alex
97 CC Sport V8 5spd
----- Original Message -----
From: Bob Tom <tigers@bserv.com>
To: <dakota-truck@buffnet.net>
Sent: Tuesday, November 20, 2001 4:12 PM
Subject: DML: Roll Pan ?
> Has anyone mated a roll pan with the Gibson
> dual rear exit cat-back exhaust? If so, were
> the exhaust cutouts a clean fit? TIA.
>
> Bob Tom Burlington, Ont., Canada
> '97 Dakota Sport, 4x2, CC, Flame red, 5.2L, auto., 3.92SG
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:32 EDT