jay & dana wrote:
>
> Also I would like to do this myself and was wondering if I could use any
> wrench that would fit out of my tool box or is there (I heard there was) a
> special tool that you have to use to replace O2 sensors?
> Any advice on this matter would be greatly appreciated.
>
> Thanks again
> Jay
There is a special tool, a special socket you buy with a slot in the side for
the wires. It makes the job a bit easier, but you don't _need_ it, a box
wrench will do fine. Be careful.
William
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:32 EDT