for the intake manifold, all you need is an inch/lbs wrench. I have a few
Craftsman that were fairly cheap, and I felt they'd likely be more accurate
than cheaper import ones.
make sure you get the proper range also, you'll need at least 72 in/lbs,
preferably higher than that. (accuracy decreases nearer the limits of
range)
__________________
Jon Smith
Raleigh, NC
'95 CC 318 4x4 auto
344rwhp/424tq
----- Original Message -----
From: "Tim Althoff" <yllwdkta@insight.rr.com>
To: "Dml (E-mail)" <dakota-truck@buffnet.net>
Sent: Saturday, December 01, 2001 5:04 PM
Subject: DML: torque-wrenches...where to get?
where should I get a decent torque-wrench? I need one to begin with but
mainly for when I switch my intakes.
I need inch-lbs & foot-lbs?
Thanks,
Tim Althoff
99 V6 RC 5-speed SY
http://go.to/yllwkdta
http://go.to/ohiomeet
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:39 EDT