I just pulled the tray out of mine today to install
the MTX thunderform. Mine had five screws holding it
in. Two are hidden in the cup holders under a piece
of rubber.
I'm not sure if removing the quarter panels is
necessary, but I did. Just remove the shoulder belt
strap and the two small screws in back. Also pull up
the door sill trim to allow it to come out. The only
thing left after that are some of the push holders.
Did anyone have any problems with the bolt holes not
lining up on the MTX thunderform? When I put a couple
bolts in one side the other side bolts were off by
an inch or so.
Brad K.
1998 Dak 4x4 CC 5.2L
-----Original Message-----
From: owner-dakota-truck@BUFFNET.NET
[mailto:owner-dakota-truck@BUFFNET.NET]On Behalf Of
Andy Levy
Sent: Sunday, December 02, 2001 9:55 AM
To: dakota-truck-moderator@bent.twistedbits.net
Subject: Re: DML: extended cab, under seats?
I think you have to remove everything (back & sides)
from the back of the
cab.
THRASHER949@aol.com wrote:
> Hey yall I makin a box for a friend for some subs
under his back seat. has
> anybody pulled the storage tubs out before? I pulled
the 3 screws but it
> wouldnt wiggle loose. Do i need to pull down the
trim around the windows
> to get it out? any comments appreciated. thanx
-- -andy andylevy@yahoo.com Maintainer, DML FAQ - http://www.dakota-truck.net/faq/ http://home.twcny.rr.com/andylevy/dakota/ '99 CC 4x4 318 auto__________________________________________________ Do You Yahoo!? Buy the perfect holiday gifts at Yahoo! Shopping. http://shopping.yahoo.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:39 EDT