Not that bad, they do cost horsepower. But my Mopar rockers are crap! I have
re-adjusted them 4 times already, Idid them last Wednesday, AND THEY NEED TO
BE DONE AGAIN! ARRGH!!!!
I think I'm gonna switch to Hughes rockers next. Did I mention that the
studs came unscrewed on two cylinders also. They suck, is my opinion! My
truck spends more time with the valve covers off than on. I have adjusted
them in several different ways and they always start ticking after a few
days. I have even had one of the adjusting nuts come off once while driving
down the road,
Mark Kuzia
flyboy01@mediaone.net
http://people.mw.mediaone.net/flyboy01/home.html
1995 Dakota 13.79 @ 102.45 mph "Fastdak"
~360ci, 5-spd, 8 3/4 rear / 3.90-SG
1994 Dakota 15.36 @ 91.56 mph
~318ci, 5-spd, 3.90 LS (bone stock, no mods)
----- Original Message -----
From: "Doug Myers" <dougmyers@starpower.net>
To: <dakota-truck-moderator@bent.twistedbits.net>
Sent: Saturday, December 08, 2001 9:07 PM
Subject: DML: how bad are the stock rockers?
> Hey guys,
>
> I'm pretty sure that my roller rockers need to be re-adjusted. I'm
> getting a loud ticking sound, and I've never re-adjusted them since I
built
> the engine. I've got about 8,000 miles on the rebuild right now. Is it
> normal to have to re-adjust aluminum rockers periodically? If so, then
thats
> leads to my next question.....
>
> How bad are the stock rockers? I've been thinking about this since I
> realized that my rockers need to be re-adjusted. Also, since my rollers
are
> aluminum, they may need periodic adjustment. I don't want to be
re-adjusting
> them every other oil change, and I don't think the stock rockers would
cost
> me any more than 5-10hp. I did some research and found out the the
380hp/360
> Mopar crate engine uses the same stock rockers and pushrods that our
engines
> leave the factory with, and it has a more radical cam (288/292 duration,
> .501/.513 lift) than my Comp Cams cam (260/264 duration, .512/.512 lift),
> therefore a higher powerband. The valvesprings they use are about the same
> specs also (mine have 120lbs seat pressure, 310 open... theirs have 140lbs
> seat pressure, and 290 open). Why wouldn't the stock rockers be good
enough
> for my engine if they're good enough for the crate engine?
>
> --
> Doug Myers
> -------------
> '99 Dakota RC/SB 5.9L/5-speed/3.92SG - 14.320@98.46mph
> R/T wheels, Nitto NT-450 275/50R17 tires, K&N Gen II FIPK, Comp Cams '604
> cam, ProGear timing chain, MP 2-bbl MPI, MP 1.92" R/T heads, Hughes'
roller
> rockers, MP polished valve covers, ASP crank pulley, MP Headers, 3"
Dynomax
> cat, 3" Flowmaster, Accel Supercoil, Magnecor KV-85 8.5mm Race Wires,
> Melling HV oil pump, Centerforce Dual Friction Clutch
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:40 EDT