I'll tell you if you promise to turn off the return notice on your emails ;)
I've seen on some '99s that there is no plenum divider, it stops about 2"
below the TB bores... I've not been able to find an answer as to why some
manifolds don't have it, yet most do.
I don't know what you're referring to by "inside casting removed", there is
a lot of casting inside the manifold ;-)
Check my webpage for more info on modding one... www.fast4x4.net
__________________
Jon Smith
Raleigh, NC
'95 CC 318 4x4 auto
344rwhp/424tq
----- Original Message -----
From: "Tim Althoff" <yllwdkta@insight.rr.com>
To: "Dml (E-mail)" <dakota-truck@buffnet.net>
Sent: Monday, December 10, 2001 6:56 PM
Subject: DML: 3.9L intake...plenum???
I just opened the intake on a 1998 3.9L dak...I am trying to modify it to
get a little more power for my 99. I was going to have the plenum taken
down 1.5" but I don't see it. I am confused! There is a little reniky
dinky divider in between the bores where the TB bolts up to but not one that
runs from front to back. So do I leave that alone or what? Also should I
get the inside casting removed?
Thanks
Tim Althoff
99 V6 RC 5-speed SY
http://go.to/yllwdkta
http://go.to/ohiomeet
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:40 EDT