Correction, fill to the edge of fill hole. this is the correct way.
----- Original Message -----
From: jay & dana <jay&dana@telus.net>
To: DML <dakota-truck@buffnet.net>
Sent: Monday, December 31, 2001 2:47 PM
Subject: DML: Fluid levels
> When changing the fluid levels (T-case, 5 spd and Diffys) why is it said
you
> should fill to 1/4 inch below the bottom of the hole? Is it that
important?
> Why can't you just fill until it starts trickling out, then wait till it
> stops then put the filler plug back in? Just wondering of too much will,
I
> don't know, blow seals or something?
>
> Thanks
> Jay
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:44 EDT