Howdy folks,
My name is Mike Styer and I have a 1993 Dakota V6 5-speed 2 wheel drive (you can check out pictures of it at my website www.geocities.com/geekfarm) It's been a long timed since I've been able to get the DML, but I am finally back.
Just this last week I replaced my entire engine. After 215,000 miles, my timing chain slipped off and I bent all six exhaust valves. It was cheaper to replace the entire engine with an one from a wrecked Dak with only 81,700 miles.
My truck is now running great except for one thing. Though it was never very quick to warm up, the engine does not want to heat up beyond 120 degrees or so (1/4 way across the heat range on the dash gauge). I though maybe it was the cold weather so I blocked the radiator, but it still wouldnt heat up, until the other night on the interstatre when the cardboard got wet and froze, causing the truck to quickly overheat. That however is the only time it has risen above 120 degrees All my seals are good,a dn there isn't any coolant leaking as far as I can see. I kept the thermostat from the new engine because it appeared to be in better shape than my old one. Any ideas?
Well thanks in advance for any help. And if anyone has any questions about pulling engines, I think I can probably help you out ;)
Thanks,
Mike Styer
1993 V6 5 speed 2wd
www.geocities.com/geek_farm
___________________________________________________
GO.com Mail
Get Your Free, Private E-mail at http://mail.go.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:49 EDT