Ok, I went into my garage and looked at my old set of plugs, I am correct on
my first reply, the large side goes to plug. when the washer is compressed
the small side mushes against the large side and make correct seal, and
correct form. if done the other way,it will be awkward in form. Proof is in
my pudding.
----- Original Message -----
From: jay & dana <jay&dana@telus.net>
To: <dakota-truck@buffnet.net>
Sent: Wednesday, January 30, 2002 2:52 PM
Subject: DML: Re: RE: 3923 gasket question
> See this is what I'm talking about, I'M SO CONFUSED :-)
> Kevin responded back saying the flat side goes against the plug, and Sean
> responds below with the flat side against the head. I just want to do
this
> right the first time. Anyone else???
>
> Thanks
> Jay
>
>
>
> >
> >The flat side goes against the cylinder head. The angled seat on the plug
> >will collapse the gasket when torqued.
> >
> >Sean
> >'92 RC Sport 3.9L 5spd - 255,000mi!
> >'01 CC SLT+ 4.7L 5spd 3.92 LSD Mobil-1!
> >http://www.twistedbits.net/WWWProfile/dakota/DnuuSncssJujU
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:54 EDT