Hey Fellas,
I've got a Hurst shifter sitting in my front room on the floor. If you want
any measurements off it, just let me know. I haven't installed it yet.
Rich - Ashburn, VA
PS. Maybe you can tell me what gaskets came with the shifter, as I am minus
these. Thanks!
-----Original Message-----
From: SEMIHEMI01@aol.com [mailto:SEMIHEMI01@aol.com]
Sent: Monday, February 04, 2002 4:56 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: Re: re: Hurst shifter
Robert,
I even took the stick out of the tower and set the tower on the tranny
with the bottom of the stick in the socket & the pivot ball was up by the
same 1/4" thickness. I even went to the dealer and looked at the gasket for
my tranny and it was right, then I compared the amount the socket ball stuck
down below the tower and it was 1/4" longer than the OEM.
Now you got me wondering if Hurst put the wrong stub shifter in the
tower
that I got. WEIRD HUH? Bill
SEMIHEMI01@AOL.COM> KB SuperCharged, 4.7L, 2001, QC,
<A HREF="http://hometown.aol.com/semihemi01">the "DAK",</A> <A
HREF="http://www.southernmopar.org/index.shtml">SouthernMopar</A>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:57 EDT