thanks, for the help...I got an email from Andy Levy with the same fix...I
think I am going to try that! Did you replace it or just reinstall it? The
reason I ask is Andy Levy had his replaced (but then again he off roads) ;)
Tim Althoff
99 RC Dak w/ V6 5-speed
http://go.to/yllwdkta
-----Original Message-----
From: victor.williams@byers.com [mailto:victor.williams@byers.com]
Sent: Friday, February 15, 2002 8:21 AM
To: dakota-truck@buffnet.net
Cc: yllwdkta@insight.rr.com
Subject: re:DML: popping noise from front...(what do I need to fix
it...not crappydodge stuff)
I guesss no new suspension parts lately? Last year I got new tie rod ends
(do not know the brand ) installed and the front end on my '95 CC popped
for a while. I re-greased all fittings and it went away.
But recently, I started getting another clunk/pop in the front end.. Most
noticable when I stopped and the front end moved up/down.
I took out the intermediate steering shaft checked it and put it back in.
The clunk went away - go figure. Try it.
I think a non mopar steering shaft with needle bearings is about $250, a
mopar one was around $230
Victor Williams / Ga
'95 DAK CC Sport,5.2L,5sp,Jacobs ign,Jardine catback, 211k miles+
>Date: Thu, 14 Feb 2002 20:11:16 -0800
>From: "Tim Althoff" <yllwdkta@insight.rr.com>
>Subject: DML: popping noise from front...(what do I need to fix it...not
crappy dodge stuff)
>
>I am getting sick of this popping noise from the front end. It does it
when
>I pull in a parking spot and I completely stop and the front end raises a
>little. it does it terribly when I go over rough pavement. It may do it
>when I turn but not positive on that. What do I need and where do I get
it.
>Also roughly how much will this cost.
>
>I prefer non Mopar parts unless they are good! not like what I have...
>
>Tim Althoff
>99 RC Dak w/ V6 5-speed
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:00 EDT