Jack Paulson wrote:
>
> Any suggestions on how to paint a diamond-plate
> aluminum tool box?
> I like how the black tool boxes look, but mine's
> aluminum.
> thank
>
hmmm, its tough to do but it can be done.
even w/ proper primer it can/will flake easier
than reg. steel etc.
strip any wax, ploish etc off it really good then
sand it all down (good luck) or sandblast it very
well.
prime it w/ "zinc oxide" primer if its avail. in
your area or whatever the replacement is.
damm state EPA rules vary so its hard to get in
some areas.
then paint it as you normally would.
> =====
> 2000 Quad Cab 4X4-Sport V-6 Automatic Sports Plus Package
> 31X10.5 tires Limited Slip 3.55 Trailer Tow Group HD Package Skid Plates
> Added:Airaid air filter,Flowmaster 3 chamber, Steel Horse Torneau cover,
> Autolite Double Platinum 3923 Plugs, Removed air horns from Throttle Body,
> new TB bolts, Taylor 8mm Wires, Cool Tape around air filter and A/C tubes,
> McGard Tailgate lock, Audiovox cut off switch & hood lock
> -Smyrna, Georgia
>
> __________________________________________________
> Do You Yahoo!?
> Try FREE Yahoo! Mail - the world's greatest free email!
> http://mail.yahoo.com/
-- http://www.kencofish.com 401-781-9642 Importer/Exporter of Goldfish,Koi,rare Predators Shipping to legal states/countries only! Permalon liners, Oase & Supreme Pondmaster pumpsmake a no-cost donation to save the rain forrests here http://rainforest.care2.com/welcome?w=981743017
Please Note: No trees or animals were harmed in the sending of this contaminant free message We do concede that a signicant number of electrons may have been inconvenienced.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:07 EDT