Yeah sounds like the TPS= throttle position sensor is not working
correctly. clean the TB well, check the PCV Valve. bad plug wires, bad
plugs, timing outta whack.
----- Original Message -----
From: David McKittrick <sysop1@rogers.com>
To: <dakota-truck@dakota-truck.net>
Sent: Thursday, March 14, 2002 7:56 PM
Subject: DML: Low idel and stalling
>
> My truck has been running rugh since I replaced my rad. After hitting a
> racoon and replaceing the rad. I decided while I was in their I would put
in
> my Robert Shaw 180. It's been about -10 ~ +10 C for the last few weeks and
> since I did the coolant system my stuck when warmed up will stall after
> comeing to a stop. The revs will drop and some times go back up but it
will
> usualy stall.
> The only other thing I did while I was working on the coolant system was
> remove and replaced the ignition coil, ideler pully and alternator. (I
> droped a bolt into a hard to get to place and had to remove the alternator
> to get at it.)
> And of cource while I was loosing off the ideler pully I broke the bolt on
> the pully wheel. Now replaced with a new ideler pully assembly.
>
> I have tryed resetting the computer 3 times now. After reseting it will
work
> for about 50km then start stalling again.
>
> Any ideas as to why my truck it stalling?
>
> David McKittrick - London, Ont.
> 98' CC Sport. 2WD, 3.9 V6, Auto, 147,000km
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:09 EDT