DAKSY wrote:
>
> Ok, DML,
> I need a few pointers (one acually). I pulled the air hat & the homebrew
> intake off , to replace the K&N filter & I noticed some oil on the left
> (passenger) side valve cover, where the hose from the air hat connects.
> Before I went in & checked the FSM, I yanked the hose, 90 deg elbow & the
> grommet out of the valve
> cover. Got everything cleaned up & ready to put back & I can't get the dang
> grommet back in the valve cover! It's in the lower 40s outside so everything
> is a little cold...
> Can I safely throw the elbow & grommet assy into a plastic cup of water & &
> throw everything into the microwave & nuke it til the water boils - in order
> to soften the grommet up? Or would it be just as easy to remove the valve
> cover & bring it in the house & heat THAT with a blowdryer in order to
> expand the hole? I don't wanna damage anything....
> HAYELP!
>
soften the grommet in hot water then
take it outside still in the cup and
quickly put it in.
start one side then push in and turn.
> Bob Smith (Daksy2K on AIM)
> DML/DML
> 2K DAKSY CC Sport +
> 3.9l; V6: 4X4
> (1 of 980 2K DAKSYs mfrd)
> For the mods,details, etc., visit us at:
>
> http://home.nycap.rr.com/daksy/
>
> (ps, we're still working on it...
> Susan on the page; me on the DAKSY! )
-- http://www.kencofish.com Ken Arnold, 401-781-9642 Importer/Exporter of Goldfish,Koi,rare Predators Shipping to legal states/countries only! Permalon liners, Oase & Supreme Pondmaster pumpsmake a no-cost donation to save the rain forrests here http://rainforest.care2.com/welcome?w=981743017
Please Note: No trees or animals were harmed in the sending of this contaminant free message We do concede that a signicant number of electrons may have been inconvenienced.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:09 EDT