While I was in Home Depot shopping for parts for my intake, I had an idea. I
looked for a PVC "T" or "Y" that was suitable for a dual-inlet intake. I
didn't see one that I thought would work well so I brainstormed that I could
take 2 90* bends (long radius) and siamese them together. I would band-saw
them, starting at where they would fit to the TB, cutting the opening right
in the middle, the saw line would run perpendicular to the opening. I would
then glue them together. I would run two 3" ducts to two K&N fliters. What
do you guys think?
Ascii art of the "Y":
* *
* *
* *
* *
* *
* *
* *
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:22 EDT