Scott,
Sounds like a good idea but check this out:
http://www.turbocity.com/JeepDualAirFilter.htm
- Bernd
-----Original Message-----
From: owner-dakota-truck@dakota-truck.net
[mailto:owner-dakota-truck@dakota-truck.net] On Behalf Of Moody, Scott J
Sent: Wednesday, April 17, 2002 7:30 AM
To: 'dakota-truck@dakota-truck.net'
Subject: DML: New idea for intake
While I was in Home Depot shopping for parts for my intake, I had an
idea. I looked for a PVC "T" or "Y" that was suitable for a dual-inlet
intake. I didn't see one that I thought would work well so I
brainstormed that I could take 2 90* bends (long radius) and siamese
them together. I would band-saw them, starting at where they would fit
to the TB, cutting the opening right in the middle, the saw line would
run perpendicular to the opening. I would then glue them together. I
would run two 3" ducts to two K&N fliters. What do you guys think?
Ascii art of the "Y":
* *
* *
* *
* *
* *
* *
* *
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:22 EDT