Eric,
thanks for the link. the intake system for the 4.7 is a bit different
though. however, i did find a pretty detailed page with one for the 4.7.
here is the link for anyone interested:
http://modernmusclecars.net/articles/coldair/
-adam
-----Original Message-----
From: owner-dakota-truck@dakota-truck.net
[mailto:owner-dakota-truck@dakota-truck.net] On Behalf Of Eric Jerman
Sent: Thursday, May 23, 2002 9:53 PM
To: dakota-truck@dakota-truck.net
Subject: DML: Re: Yes, another NUG...
Don't know if this is what you are looking for as far as an intake...but
www.gibsdakota.com will give you the parts list for making your own...I
used his info and made one for myself...cost only $50 as compared to
$170 for an AIRAID and it does essentially the same thing...only it
doesn't have the pretty sticker on it...check his page out and see if
that will work for you...like I said I made one myself for my truck and
I noticed a difference right off the bat...but I don't know if there is
any difference between the intake needed for a 4.7 and a 3.9... I have a
pic of mine as well on: http://www.angelfire.com/empire/dakon18s
----- Original Message -----
From: "crm" <tb.crm@verizon.net>
To: <dakota-truck@dakota-truck.net>
Sent: Thursday, May 23, 2002 10:16 PM
Subject: DML: Yes, another NUG...
> Can anyone recommend a good link for a DIY cold air intake? Since K&N
> hasn't released theirs for the 4.7, I figure I can fashion up
> something, but would like some pointers and an idea of what I'll need
> to buy. Or alternately, is there another manuf out there that has made
> something decent for that engine?
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:36 EDT