Don't know if this is what you are looking for as far as an intake...but
www.gibsdakota.com will give you the parts list for making your own...I used
his info and made one for myself...cost only $50 as compared to $170 for an
AIRAID and it does essentially the same thing...only it doesn't have the
pretty sticker on it...check his page out and see if that will work for
you...like I said I made one myself for my truck and I noticed a difference
right off the bat...but I don't know if there is any difference between the
intake needed for a 4.7 and a 3.9...
I have a pic of mine as well on:
http://www.angelfire.com/empire/dakon18s
----- Original Message -----
From: "crm" <tb.crm@verizon.net>
To: <dakota-truck@dakota-truck.net>
Sent: Thursday, May 23, 2002 10:16 PM
Subject: DML: Yes, another NUG...
> Can anyone recommend a good link for a DIY cold air intake? Since K&N
> hasn't released theirs for the 4.7, I figure I can fashion up something,
> but would like some pointers and an idea of what I'll need to buy. Or
> alternately, is there another manuf out there that has made something
> decent for that engine?
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:36 EDT