How to unsubscribe
First, ask your Internet Provider to mail you an Unsubscribing
Kit. Then follow these directions. The kit will most likely be
the standard no-fault type. Depending on requirements, System
A and/or System B can be used. When operating System A,
depress lever and a plastic dalkron unsubscriber will be
dispensed through the slot immediately underneath. When you
have fastened the adhesive lip, attach connection marked by
the large "X" outlet hose. Twist the silver- coloured ring one
inch below the connection point until you feel it lock.
The kit is now ready for use. The Cin-Eliminator is activated
by the small switch on the lip. When securing, twist the ring
back to its initial condition, so that the two orange lines
meet. Disconnect.
Place the dalkron unsubscriber in the vacuum receptacle to the
rear. Activate by pressing the blue button.
The controls for System B are located on the opposite side.
The red release switch places the Cin-Eliminator into
position; it can be adjusted manually up or down by pressing
the blue manual release button. The opening is self-
adjusting. To secure after use, press the green button, which
simultaneously activates the evaporator and returns the Cin-
Eliminator to its storage position.
You may log off if the green exit light is on over the
evaporator. If the red light is illuminated, one of the Cin-
Eliminator requirements has not been properly implemented.
Press the "List Guy" call button on the right of the
evaporator. He will secure all facilities from his control
panel.
To use the Auto-Unsub, first undress and place all your
clothes in the clothes rack. Put on the velcro slippers
located in the cabinet immediately below. Enter the shower,
taking the entire kit with you. On the control panel to your
upper right upon entering you will see a "Shower seal" button.
Press to activate. A green light will then be illuminated
immediately below. On the intensity knob, select the desired
setting. Now depress the Auto-Unsub activation lever. Bathe
normally.
The Auto-Unsub will automatically go off after three minutes
unless you activate the "Manual off" override switch by
flipping it up. When you are ready to leave, press the blue
"Shower seal" release button. The door will open and you may
leave. Please remove the velcro slippers and place them in
their container.
If you prefer the ultrasonic log-off mode, press the indicated
blue button. When the twin panels open, pull forward by rings
A & B. The knob to the left, just below the blue light, has
three settings, low, medium or high. For normal use, the
medium setting is suggested.
After these settings have been made, you can activate the
device by switching to the "ON" position the clearly marked
red switch. If during the unsubscribing operation you wish to
change the settings, place the "manual off" override switch in
the "OFF" position. You may now make the change and repeat the
cycle. When the green exit light goes on, you may log off and
have lunch. Please close the door behind you.
Joel Esler
Network Security Analyst
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:51 EDT