Sorry to catch this thread late, but what is the cost for the Viper fan
assembly?
Thanks,
Rich - Ashburn, VA
-----Original Message-----
From: George S Willhite [mailto:gswillhite@ualr.edu]
Sent: Friday, July 19, 2002 11:20 AM
To: DML
Subject: DML: Viper Fan was: Questions for everyone
I know the Viper fan is 24x17, but anyone know
the thickness or depth? I wouldn't mind trying this
with my new radiator.
George
Post from the past by TonyC:
The entire assembly (fan and shroud) measure 24x17. The fan itself is 17 in
diameter. There are 2 flavors out there. The earlier one has the fan
centered, the later one doesn't. I have the earlier version.
They are a 2 speed setup. One ground, 2 hots. Energize one hot - low
speed, energize the other hot - hi speed. The Viper uses 2 relays. One acts
as an on/off, the other takes a feed from the PCM and determines hi or low.
I'm wiring it with a single relay to run high speed only. Based on a temp
sensor, or a manual override switch.
TonyC
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:05:05 EDT