"Wes Weems" <wweems@fix.net> wrote:
: will I need new bearings lifters etc? My FSM shows how to pull the lifters
: and clean em, and they work for now... I am just so damn broke I cant afford
: anythign. =(
No, you shouldn't need to change the bearings and lifters unless they
are damaged. (Normally you would replace the lifters on a flat tappet
cam, but since the Magnums use a roller cam, they can be re-used). As
far as the bearings go, if they are bad, the engine would probably need
to be pulled to replace them anyway, so hope that they are good. :-)
(They should be OK though.)
---Jon-
.---- Jon Steiger ------ jon@dakota-truck.net or jon@jonsteiger.com -----. | I'm the: AOPA, DoD, EAA, NMA, NRA, SPA, USUA. Rec & UL Pilot - SEL | | '70 Barracuda, '92 Ram 4x4, '96 Dakota, '96 Intruder 1400, '96 FireFly | `----------------------------------------- http://www.jonsteiger.com ----'
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:05:22 EDT