(no subject)

From: blkwidow1@primary.net
Date: Mon Oct 14 2002 - 17:12:24 EDT


)
Date: Mon, 14 Oct 2002 16:11:18 -0500
Subject: Re: DML: Gen III 15x8 On A Gen II
From: "Jon N. Benignus" <blkwidow1@primary.net>
To: <dakota-truck@dakota-truck.net>,
   <dakota-truck-moderator@bent.twistedbits.net>
Message-ID: <B9D09D26.1361E%blkwidow1@primary.net>
In-Reply-To: <aof80b$71j$1@bent.twistedbits.net>
Mime-version: 1.0
Content-type: text/plain; charset="US-ASCII"
Content-transfer-encoding: 7bit

> Will the Gen III 15x8 rims fit on a Gen II truck? I'd like to put a set on
> : my '95. I know bolt pattern is the same but what about backspacing?
Here's my two cents:
Yes, they fit, with one caveat: If you use the traditional wheel weights,
you will need to grind the point of the upper control arm for clearance.
IMHO, this should be done anyway. I have no problems with mine whatsoever
without a spacer. Center caps fit fine. Note-I mounted BFG 235/75-15 AT
tires, and without the spacers they do tend to rub while at full lock on the
weather "flap" material in the wheel well. With a fender washer (no pun
intended) on each stud, the problem is all but eliminated.
For lug nuts, go to Auto Zone and get lug nuts for aluminum wheels, 1/2 dia.
RH thread. These will have a much larger mating surface on them compared to
the OEM. They will be longer, too. IIRC, I got all 24 for about $20 this
past spring.

HTH
Jon
STL
92 RC LB 3.9 auto



This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:17 EST