I'd suggest using a flowmaster 50 series SUV model. It's a bit deeper than
the 40 series. I had a 40 series and found it to be a bit to raspy on the
V6. If you want i can make a few sound clips of my truck (also have one of
my truck in 40 series). I have a 2.5 inch pipe through the muffler and then
over the axle i welded a 3" pipe to it. i wanted it to look like a nice big
exhaust (carries the sound better) when i had it bent to the side (single
exit stock location). If you do duals i would go with a 2.5 into muff and
1.75-2" out.
Tim Althoff
www.yllwdkta.com
-----Original Message-----
From: Josh Battles
To: dakota-truck-moderator@bent.twistedbits.net
Sent: 10/22/02 5:05 PM
Subject: DML: Re: RE: V6 exhaust?
what size tubing did you use?
""Gabriel A. Couriel"" <BigGabe@fiufiji.com> wrote in message
news:LGEHJPEPBFBBEPPBEOFMGENACBAA.BigGabe@FIUFIJI.com...
>
> well, i've got a flowmaster 40 series on my V6. its a bit loud at
start
up,
> but once the engine and exhaust warm up enough (about 5 minutes), the
noise
> dies down.
>
> Gabe Couriel
>
> http://frontpage.tripod.com/fijigabe0
>
> ---
> 1998 Dodge Dakota Club Cab Sport
> 3.9L V6
> 5-Speed Manual Transmission (AX-15)
> 3.21 Open Rear End
>
>
> -----Original Message-----
> From: owner-dakota-truck@bent.twistedbits.net
> [mailto:owner-dakota-truck@bent.twistedbits.net]On Behalf Of Josh
> Battles
> Sent: Tuesday, October 22, 2002 3:51 PM
> To: dakota-truck-moderator@bent.twistedbits.net
> Subject: DML: V6 exhaust?
>
>
>
> Hey, I was wondering what exhaust would give me a nice throaty sound
for
my
> V6 and not negatively impact my low end torque. I'd like to use a
dual
rear
> exut setup with nice long chrome tips...chrome looks good next to
patriot
> blue... Any suggestions?
>
> Thanks,
>
> Josh
>
> 2000 CC Base V6
>
>
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:18 EST