Kevin Sellstrom <ksellstr@softcom.net> wrote:
[...]
: While I was at it, I managed to tear the end off one of the Mopar plug
: wires...time for new/better ones. what have people had good experience
: with? MSD (who only sell a universal set for these engines), Mopar
: Performance, etc?
MSD sells an 8.5mm SuperConductor set for the 5.2/5.9. I
believe the part number is 32189. Magnecor is probably the
best wire out there, but they are pricey. I recently ordered
some MSD SuperConductors for my 440 and the fit was terrible -
the boots were way too long. Maybe they would work on a B
body, but there wasn't even room for the boots to clear the
fenders on the cuda. Anyway, I replaced them with a set of
Taylors which had an excellent fit, and were about half the
price. They seem like a good wire, but I suppose time will
tell. The MSD set for my Dakota was a good fit. (Check out
the install if you like, in the "upgrades and modifications"
section of the DML Home Page - www.dakota-truck.net) I
replaced the MSD wires with a set of Magnecors, but only
because one of them fell out of the loom, laid up against a
header pipe and burned through the insulation.
---Jon-
.---- Jon Steiger ------ jon@dakota-truck.net or jon@jonsteiger.com -----. | I'm the: AOPA, DoD, EAA, NMA, NRA, SPA, USUA. Rec & UL Pilot - SEL | | '70 Barracuda, '92 Ram 4x4, '96 Dakota, '96 Intruder 1400, '96 FireFly | `----------------------------------------- http://www.jonsteiger.com ----'
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:19 EST