I recently replaced all the shocks with Rancho RSX shocks and now when I go
over large seams in the road, I get a clunk from the rear end. Almost like
I had something loose in the bed that would bounce.
Do the Rancho shocks need a sleeve to go inside the bushing to keep it from
bouncing on the bolt? I checked most of the bolts in the suspension and
they are all tight. I did have to tighten up one of the stabilizer bar
bolts that hung on the rubber drop piece on the driver's side.
I also want to go back and replace all the shock bolts and want to know what
type of hardware to use. I think it's Grade 8.
Thanks!
Chris Reck
Chicagoland, IL
'99 Dakota Sport + CC 4x4 V6 (Deep Amethyst)
Autolite 3923, 7.5mm Bosch plug wires, Jet Stage 1 Chip, Custom K&N 6x9 air
intake, Rancho RSX shocks (4), Pioneer full audio system, BF Goodrich
32x11.5r15 T/A KO tires
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:43 EST