Ok, well, guess nobody has any clue or can take the measurements :(
Guess I'll figure out another route to find out what the measurements are
suppose to be....
----- Original Message -----
From: "Ken Allgood" <kenallgood@cox.net>
To: <dakota-truck@dakota-truck.net>
Sent: Wednesday, February 05, 2003 8:10 PM
Subject: Mounting for bumper
> Ok, I need some info on measurements here to see if the replacement bumper
> is off, or my frame is off (replacement bumper does not line up
> correctly)... note, this is not a bumper from dealership, but aftermarket
> OEM replacement (are you allowed to say that?? hehe)
>
> The point on the FRAME that the mounting brackets are located, measuring
> from furthest inside point on each side is 34" apart (inside of frame on
> left side to inside of frame on right side).
> Now, the mounting bracket that is mounted on the frame, measuring from
> inside bolt hole to inside bolt hole is 31"
>
> Mounting bracket on old bumper: from middle of inside hole on one side to
> middle of other inside hole is 31.5". On the replacement bumper, it's
> 30.5".
>
> If anyone can take some measurements for me, or maybe point me to where in
> the FSM I could find these measurements, I would greatly appreciate it.
The
> only info I could find in the FSM was going to middle of frame on left to
> middle of frame on right was 982 sometime.. centimeters maybe???
>
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:50 EST