Bill,
Yes, there is an internal clip retainer. It takes a special tool, or you
can make a shim to do the same thing. I think the tool cost around $8-$10.
I made a plastic shim and use it when ever I need to disconnect the line.
It isn't hard, just takes a little time.
Rich - Ashburn, VA
-----Original Message-----
From: Bill Urbanovsky [mailto:bill@nacoma.cc]
Sent: Monday, February 24, 2003 9:38 AM
To: dakota-truck@dakota-truck.net
Subject: DML: Fuel line connector
Hello,
1996 Dakota 3.9 v6. (throttle body)
I am attempting to remove the fuel line where it attaches to the injector
manifold. I removed the outer clip but there appears to be an internal clip
of some sort holding the connection together. From looking at a manifold
that has the line removed it appears that this internal clip is made of
plastic. Does this reqire a special tool?
Thanks.
Bill
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:52 EST