"William H. Hiatt III" <william@hiatt.net> wrote:
[...]
: 1) Something is obviously wrong in my setup. What is it?
I'm assuming that you are still running with 3 degrees less timing
than stock? If so, I'm not sure that this is your entire problem,
but it probably isn't helping. If you know anyone with a stock
computer, you might want to try swapping it out and testing again.
You might also want to verify that the cams are degreed properly.
Just as a side note, you probably won't notice a change on the
dyno because of the switch from the Z tube to the GTS hood, because
you're sitting in static air, and the hood was probably up for testing
also.
---Jon-
.---- Jon Steiger ------ jon@dakota-truck.net or jon@jonsteiger.com ------. | I'm the: AOPA, DoD, EAA, NMA, NRA, SPA, USUA. Rec & UL Pilot - SEL | | 70 Cuda, 90 Dak 'vert, 92 Ram 4x4, 96 Dak, 96 Intruder 1400, 96 FireFly | `------------------------------------------ http://www.jonsteiger.com ----'
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:00 EST