Hey all,
My 390 stroker has and exhaust leak on the drivers side. Its coming from the
top of the header flange (doug thorley headers) on both the front and rear
exhaust ports (R/T Heads) I think it may be that the flange is a bit warped
(slightly), would it be ok to use 2 manifold gaskets to get a better seal? or
is there anonther route I should try. I have to say it might just be that the
gasket is bad (even though it was brand new) but I'm asking just in case it
isn't.
John S
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:12 EST