Rascal,
Thanks, There is plenty of room on the opposite side. I have a flat
washer against the plastic, then a split ring washer and a nut.
As for the wiring, I am in the process of redoing my wiring diagram
based on your comments and others. I only have the low speed hooked up
right now, waiting for parts to finish it off.
Thanks again,
Bill
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Rick
Barnes
Sent: Wednesday, April 23, 2003 4:25 AM
To: dakota-truck@dakota-truck.net
Subject: DML: RE: RE: RE: My Viper Fan Wiring.
Bill, those are the most awesome detail pics, thanks so much. I was not
sure how I would mount it but your brackets are perfect. The brackets
are
just screwed into the plastic then, are there nuts holding those screws
in?
Yes, I would not think that both wires make the fan high speed, likely
one
is high, another low. I think I am going to use my extra Black Magic
controller but will add a relay between the BM controller and the fan.
Rascal
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Bill
Nissley
Sent: Wednesday, April 23, 2003 4:59 AM
To: dakota-truck@dakota-truck.net
Subject: DML: RE: RE: My Viper Fan Wiring.
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:12 EST