My '01 QC had the 9 1/4 in it. I think it's based on the option that are
ordered but I don't remember which one put it on. Only had 3.55's in it
and was just a 4x2. Go figure.
Jeff Durling
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of
scsilverdak
Sent: Thursday, June 12, 2003 10:29 PM
To: dakota-truck@dakota-truck.net
Subject: DML: Re: Rear Axle
>From what I've seen of the R/T's I've worked on.........
They use a 9 1/4 rearend similar to those used in the Durango.
Standard issue Dak's .....4wd included
use the 8 1/4 rearend...
Ron-
Performance consultant
Muscletrucks.net
----- Original Message -----
From: <DodgeDe@cs.com>
To: <compuserve@dakota-truck.net>
Sent: Thursday, June 12, 2003 8:21 PM
Subject: DML: Rear Axle
>
> Well, I'm on the way to getting the truck done for Carlisle. Large
parts
of
> it are Orange (tor red) and the shaker is on. But the axle is bent.
>
> Question is the rear axle for an 2000 R/T the same as all gen III
Dakota.
I
> don't always trust the junk yard when the say it will work on a R/T as
> sometimes the R/T isn't listed.
>
>
> Related question Can anyone E-mail the axle change section from the
service
> manual. I don't want any surprises.
>
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:27 EST