""greg conner"" <dodgeboy93@hotmail.com> wrote in message
news:Law12-F46WD661HU8df0005d711@hotmail.com...
>
> On a side note, I doubt your 92 will see much gain from switching to a set
> of headers. The 92/93 trucks had factory high output manifolds. I
suspect
> they flow very closely to that of the jba headers. However the headers do
> look 10x better. really clean up the engine compartment.
Greg, the thing is, I took the casting numbers that are supposed to be on
the manifolds from the DML FAQ, and compared that to the numbers cast into
the manifolds on my truck, and they do not match. After looking again, the
numbers I've been looking at from the FAQ are probably for the V8
(driver-side: 53006617, p-side: 53006618)
The numbers cast into my manifolds are: 53005784 on the passenger side, and
53005785 on the driver side. I'm wondering if Bernd could perhaps look up
the specs, or if anyone knows where I could find info on those two casting
numbers, it would be much appreciated.
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:30 EST